Displaying And Maintaining Ssh; Stelnet Configuration Examples; Password Authentication Enabled Stelnet Server Configuration Example - HP VSR1000 Security Configuration Manual

Displaying and maintaining SSH

Execute display commands in any view.
Task
Display the source IP address or source interface
information configured for the SFTP client.
Display the source IP address or source interface
information configured for the Stelnet client.
Display SSH server status information or session
information on an SSH server.
Display SSH user information on the SSH server.
Display the public keys of the local key pairs.
Display the public keys of the SSH peers.

Stelnet configuration examples

Unless otherwise noted, devices in the configuration examples are in non-FIPS mode.
If you configure an Stelnet server in FIPS mode, follow these guidelines:
The modulus length of the key pair must be 2048 bits.
•
Do not generate a DSA key pair on the Stelnet server. Only RSA key pairs are supported.
•
Password authentication enabled Stelnet server configuration
example
Network requirements
As shown in
You can log in to the router through the Stelnet client (SSH2) that runs on the host.
•
After login, you are assigned the user role network-admin for configuration management.
•
The router acts as the Stelnet server and uses password authentication.
•
• The username and password of the client are saved on the router.
Figure 65 Network diagram
Configuration procedure
1. Configure the Stelnet server:
Figure 65:
Command
display sftp client source
display ssh client source
display ssh server { session | status }
display ssh user-information [ username ]
display public-key local { dsa | rsa } public [ name
publickey-name ]
display public-key peer [ brief | name publickey-name ]
261