Master/Slave Built In Preprogrammed Function; Dmx Controller - ACME Festival LED-787 User Manual

10
Only for remote control: By connect to the 1/4'' microphone jack to control the unit for
Stand by, Function and Mode function.
11
DMX output: For DMX512 link, use 3-pin XLR plug cable to link the next unit.
12
DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal
13
Mains output: Connect to supply mains power for the next unit.
14
Mains input: Connect to supply mains power.
3.2 Main Function
To select any functions, press MENU button until the required one is shown on the display.
Select the function by ENTER button and the display will blink. Use DOWN and UP button to
change the mode. Once the required mode has been selected, press ENTER button to
setup or it will automatically return to the main functions without any change after idling one
minute. Back to the functions without any change press MENU button. The main functions
are shown below:
5-

4.1 Master/Slave Built In Preprogrammed Function

By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
(show 1) or ...or
(random show),
input jack will have nothing plugged into it, and its master LED will be constantly on and
sound LED will flash to the music. The other units will have to select
(2 light show) mode, Their DMX cables plugged into the DMX input jacks (daisy
chain) and the slave LED lights will be constantly on.
2-light show
In slave mode , means the unit works as the master unit and
show. In order to create a great light show, you can set
contrast movement to each other, even if you have two units only.
4.2. Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. There is a
terminator for connect the easy controller inside the fixture. By
connecting the cable into DMX IN waterproof cable entry gland to the
CA-8 terminator of the first fixture, you will find that the remote control on
the first fixture will control all the other fixtures for Stand by, Function and
Mode functions.
Blackout Blackout the unit
1. White Strobe
2. Color Strobe Select Show
Function
3. Sound White Strobe (Show 0-12)
4. Sound Color Strobe
Sound/Strobe Show
Mode
(LED OFF) (LED ON)

4.3 DMX Controller

Using universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
and select
(show 12) and speed. Its DMX
(normal) or
means 2-light
on the second unit to get
Select Speed
Select Color 1. Fast
(Color 1-15) 2. Middle
3. Slow
LED slow blinking LED fast blinking
is showing on the display. Pressing ENTER
10-