Table of Contents
Advertisement
button, and use DOWN and UP button to select
confirm and use DOWN and UP button to adjust the value between 125 and 255, once select press
ENTER button to setup or automatically exit menu mode without any change after one minute. To
go back to the last function without any change press the MENU button.
Fixture Hours
Press the MENU button up to when the
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button.
Software version
Press the MENU button up to when the
button and the display will show the version of software of the unit. To go back to the functions
press the MENU button again.
4. How to Control the Unit
You can operate the unit in three ways:
1. By master/slave built‐in preprogram function
2. By easy controller
3. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will
be affected at once. Every time you turn the unit on, it will show "
all the motors to their 'home' position. After that the unit will be ready to receive DMX signal or
run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
The fixture will allow you to link 16 fixtures together and operate without a controller. In
Master/Slave mode, the first fixture whose DMX input jack has with nothing connect will be
master automatically, set other units to slave 1 or slave2 or ... slave 16 via menu, then the first unit
10A
,
or
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
, press ENTER button to
" on the display and move
Advertisement
Table of Contents
