How To Control The Unit; Master/Slave Built In Preprogrammed Function; Dmx Controller - ACME MP-90 RGBW User Manual

Stage pro 90

Table of Contents

Fixture Hours

Press the MENU button up to when

the display will show the number of working hours of the unit. To go back to the functions press the

MENU button.

Software version

Press the MENU button up to when

the display will show the version of software of the unit. To go back to the functions press the

MENU button again.

4. How To Control The Unit

You can operate the unit in three ways:

1. By master/slave built-in preprogram function

2. By DMX controller

No need to turn the unit off when you change the DMX address, as new DMX address setting will be

effected at once. Every time you turn the unit on, it will show "MP90" on the display and move all

the motors to their 'home' position. After that the unit will be ready to receive DMX signal or run

the built in programs.

By linking the units in master/slave connection, the first unit will control the other units to give an

automatic, sound activated, synchronized light show. This function is good when you want an

instant show.

2-light show

In slave mode, Slave1 or Slave 2 means 2-light show. In order to create a great light show, you can

set Slave1 or Slave 2 on the second unit to get contrast movement to each other, even if you have

two units only.

Use universal DMX controller to control the units, you have to set DMX address from 1 to 512

channel so that the units can receive DMX signal.

Press the MENU button up to when

the display will blink. Use DOWN and UP button to change the DMX512 address. Once the address

is blinking on the display. Pressing ENTER button and

is showing on the display. Pressing ENTER button and

10A

Table of Contents