How To Control The Fixture - ACME Festival LED-787 User Manual

Display Inverse
Press MENU button until is blinking on the display. Use DOWN and UP button to
select (normal) or (inverse), press ENTER button to setup. Back to the
functions without any change press MENU button.
Self-Test
Press the MENU button up to when the
button and the unit will run the built-in programmer for self-test. To go back to the functions
press the MENU button.
Fixture Hours
Press the MENU button up to when the
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button.
Software version
Press the MENU button up to when the
button and the display will show the version of software of the unit. To go back to the
functions press the MENU button again.

4. How To Control The Fixture

You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show "787" on the
display. After that the unit will be ready to receive DMX signal or run the built in programs.
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
9- 6-