Master/Slave Built In Preprogrammed Function; Dmx Controller; Dmx 512 Configuration - ACME MP-400Z IP User Manual

4.1 Master/Slave Built In Preprogrammed Function

By linking the units in master/slave connection, the first unit will control the other units to give an
automatic, sound activated, synchronized light show. This function is good when you want an
instant show. You have to select show for the first unit. Its DMX input jack will have nothing
plugged into. The other units will be slave mode automatically.

4.2 DMX Controller

If you use a universal DMX controller to control the units, you have to set DMX address from 1 to
512 so that the units can receive DMX signal.
Press the MENU button to enter menu mode, select DMX Functions, press the ENTER button to
confirm, use the UP/DOWN button to select DMX Address, press the ENTER button to confirm,
the present address will blinking the display, use the UP/DOWN button to adjust the address from
001 to 512, press the ENTER button to store. Press the MENU button back to the last menu or
idling let the unit idle one minute to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
5 channels
7 channels
9 channels

4.3 DMX 512 Configuration

5 Channels mode:
CHANNEL
1
2
Unit 1
Address
1
1
1
VALUE
All LED Red
000-255 0-100%
All LED Green
000-255 0-100%
12B
Unit 2 Unit 3
Address Address
6
8
10
FUNCTION
Unit 4
Address
11 16
15 22
19 28