Home Position Adjustment; How To Control The Unit; Master/Slave Built-In Preprogrammed Function; Dmx Controller - ACME SAM-50 User Manual

Software Version
Press ENTER button and turn jog wheel until Software Version is shown on the
monitor. Pressing ENTER button and the display will blink. Use jog wheel to select the (A)
or (B) or (C) or (D) mode. Once the mode has been selected, press ENTER button to
setup or automatically return to the main functions without any change after 10 seconds.
Back to the previous functions without any change press ESC button.
Reset
Press MENU button until is blinking on the display. Pressing ENTER button and
Reset
all channels of the unit will return to their standard position. Back to the functions press
MENU button again.

5.3 Home position adjustment

Pan Offset
Press ENTER button for at least 5 seconds into offset mode, use jog wheel until
is shown on the monitor. Pressing ENTER button and the display will blink. Use
offset
jog wheel to adjust the pan home position. Once the position has been selected, press
ENTER button to setup or automatically return to the offset functions without any change
by press ESC button.
10-

6. How to Control the Unit

The unit can be controlled by any universal DMX controller: No need to turn the unit off
when you change the DMX address, as new DMX address setting will be effected at once.
Every time you turn the unit on, it will show "SMM-50 resetting..." on the monitor and move
the motors to it's 'home' position and you may hear some noises for about 20 seconds.
After that the unit will be ready to receive DMX signal.
6.1 Master/Slave Preprogrammed Function
When setting the series units in master/slave connection, the first one will be recognized
as master role automatically. The master can cooperate with others linkages as salve to
display automatic, sound activated synchronized light show. It provides an instant show
without complicated setting. You have to programming the movement first. Its DMX input
jack will have nothing plugged into it, and Its master LED will be constantly on. The other
units will have to set in slave mode, Their DMX cables plugged into the DMX input jacks
(daisy chain) and the slave LED lights will constantly on.
Pan

6.2 DMX Controller

If you use a universal DMX controller to control the units, you have to set DMX address
from 1 to 512 so that the units can receive DMX signal. Press MENU button until
is shown on the display. Pressing ENTER button and the display will blink. Use
Address
DOWN and UP button to change the DMX512 address. Once the address has been
selected, press and keep ENTER button pressed until the display stops blinking or storing
automatically 8 seconds later.
Please refer to the following diagram to address your DMX512 channel for the first 5 units.
Start DMX address
Fixture Fixture1 Fixture 2
1 6
11-
DMX
Fixture 3 Fixture 4
11 16