How To Control The Unit; Master/Slave Built-In Preprogrammed Function; Dmx Controller - ACME MH-575S User Manual

Focus Adjust
Press the MENU button for at least 5 seconds into offset mode, use DOWN and UP button
up to when the is shown on the display. Pressing ENTER button, the unit will focus
on the center position. Use DOWN and UP button to adjust focus, this settings only for offset
mode to adjust home position. To go back to the main functions without any change after 8
seconds
Shutter Adjust
Press the MENU button for at least 5 seconds into offset mode, use DOWN and UP button
up to when the is shown on the display. Pressing ENTER button and the display
will blink. Use DOWN and UP button to adjust the Shutter home position. Once the shutter
has been selected, press the ENTER button to setup or automatically return to the offset
functions without any change press the MENU button again, To go back to the main
functions without any change after 8 seconds.

5. How To Control The Unit

You can operate the unit in three ways:
1. Master/slave built-in preprogram function
2. Universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show M575 on the
display and move all the motors to their 'home' position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal or run the built-in
programs.

5.1 Master/Slave Built-In Preprogrammed Function

You can select blackout mode
mode while the unit is turned on. By linking the units in master/slave connection, the first unit
will control the other units to give an automatic, sound activated, synchronized light show.
This function is good when you want an instant show. You have to select show (show 1, 2, 3,
4) modes by easy controller . Its DMX input jack will have nothing plugged into it, and Its
master LED will be constantly on and sound LED will flash to the music. The other units will
have to set in slave mode and select
in (yes blackout) or
(Master) or
16-
(2 light show) mode, Their DMX cables plugged into the DMX input jacks (daisy
chain) and the slave LED lights will constantly on.
2-light show
In
and
on the second unit to get contrast movement to each other, even if you have two units only.

5.2 DMX Controller

If you use a universal DMX controller to control the units, you have to set DMX address from
1 to 512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the MENU button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
13 Channels:
(no blackout)
(normal) or
(slave mode), (Master) or
means 2-light show. In order to create a great light show, you can set
is shown on the display. Pressing ENTER
17-
means the unit works normally