Related Manuals for ACME LED-ST1000
Summary of Contents for ACME LED-ST1000
- Page 1 Ultra Strobe LED-ST1000 Innovation, Quality, Performance User Manual Please read the user manual before use 15 B ...
- Page 2 Single Flash Single flashes can be achieved by pressing the SINGLE FLASH button. Switch on the “BLACK OUT” and indicator LED light up, to press the SINGLE FLASH button for triggering a single flash effect. 6. Technical Specifications AC power ........100 - 240 V , 50/60 Hz AC mains power cable .
- Page 3 Important: Do not terminate the data link when using the BF-04D! 6， Technical Specification…………………………………………….14 The remote controller connects to The LED-ST1000 with a 3-pin XLR data cable. Additional LED-ST1000 may be connected in series, output to input. Note, however, that the data link must not be terminated as described DMX controllers and the LED-ST1000 should change to the remote control function.
- Page 4 Standby, Function and Mode selection Warning: This product is for professional use only! It is not for household use. The LED-ST1000 presents risks of lethal or severe injury due to fire and Blackout the unit (the LED indicator will light on/off STAND BY heat, electric shock, ultraviolet radiation, and falls.
- Page 5 Hz power supplies or from 0 to 20 flashes per second on 60 Hz power supplies, on Do not operate the fixture if the ambient air temperature (Ta) exceeds 40° C (104° channel 3 in the 3- and 4-channel DMX modes. Flash rate is also controllable in 1- and 2-channel DMX mode.
- Page 6 2. Rear Panel Mains input/output: Connect to supply mains power, and connect to supply mains power for the next unit. Fuse holder: T6.3A 3. LED display LED indicator: DMX CONTROL SUMMARY Signal Intensity Flash Signal input present Flash intensity can be set from minimum (blackout) to maximum on 1-channel DMX modes, channel 2 in 2-channel DMX modes and channel 1 in the 3- and 4-channel Master Master...
- Page 7 3. Preparation for Use main menu, please hold MENU button for 1 second. INSTALLATION The LED-ST1000 may be installed in any orientation. The mounting bracket provides one 12 mm holes for direct fastening or attachment of rigging clamps. Temperature 4. MAIN FUNCTION...
- Page 8 will return to main interface. If you want back to main menu, please hold MENU button for 1 second. Sound Mode Select the , press the ENTER button. Use the DOWN and UP Channel mode setting button to select .Sound mode will be available once lighting Select CHMD option, press ENTER button to confirm your selection.
Need help?
Do you have a question about the LED-ST1000 and is the answer not in the manual?
Questions and answers