234
If and when
Luggage compartment light*
– Remove the tulip-shaped fitting by pressing on its inside edge
(arrow) using the flat side of a screwdriver
– Press the bulb sideways and remove it from its housing
⇒ F ig.
188.
Jump-starting
Jump leads
The jump lead must have a sufficient wire cross section.
If the engine fails to start because of a discharged battery, the battery can
be connected to the battery of another vehicle to start the engine.
Jump leads
Jump leads must comply with standard DIN 72553 (see cable manufactur-
Fig. 187 Luggage com-
er's instructions). The wire cross section must be at least 25 mm
partment light.
engines and at least 35 mm
● The vehicles must not touch each other, otherwise electricity could flow
as soon as the positive terminals are connected.
● The discharged battery must be properly connected to the on-board net-
work.
Fig. 188 Luggage com-
partment light.
⇒ F ig.
187.
2
for diesel engines.
Note
2
for petrol