264
If and when
Sun visor light
– Carefully remove the lamp, using the flat side of the screwdriver,
as shown in the figure
Fig. 178 Removing sun
visor light
Fig. 179 Removing sun
visor light
⇒ fig.
179.
– Remove the bulb, moving it in the direction of the arrow and
⇒ fig.
outwards
179.
– Installation is done in the reverse order.
Jump-starting
Jump leads
The jump lead must have a sufficient wire cross section.
If the engine fails to start because of a discharged battery, the battery can be
connected to the battery of another vehicle to start the engine.
Jump leads
Jump leads must comply with standard DIN 72553 (see manufacturer's docu-
mentation). The wire cross section must be at least 25 mm
2
and at least 35 mm
for diesel engines.
Note
•
The vehicles must not touch each other, otherwise electricity could flow as
soon as the positive terminals are connected.
•
The discharged battery must be properly connected to the vehicle elec-
trical system.
2
for petrol engines