Seat Ibiza Owner's Manual page 235

– Remove the connector and extract the bulb. After changing the
bulb, fit the connector again.
– Place the light in its moulding, pressing the left side. Once it is
fitted into place, press the right side until you hear a click.
Interior light and front reading light
To remove the glass
– Insert a fine screwdriver between the casing and the glass
⇒ F ig.
186.
– Carefully remove the glass, levering it to avoid possible dam-
age.
To replace the bulbs
– Pull the bulbs outwards.
– To remove the central bulb, hold and press to one side.
Safety
Fig. 186 Front reading
light.
Operation
Assembly
– Proceed in the reverse order, pressing gently on the outer edge
of the side light.
 – First fit the glass with the fastening tabs over the frame of the
switch. Next press the front part until the two long tabs click on
the support.
Additional brake light*
Given the difficulty involved in the replacement of this light it should be
done by the Technical Service.
Advice
If and when


Technical specifications
233