Table of Contents
Advertisement
Sun visor light
– Carefully remove the lamp, using the flat side of the screwdriv-
er, as shown in the figure
Safety First
Fig. 194 Removing sun
visor light
Fig. 195 Removing sun
visor light
⇒ F ig.
195.
Operating Instructions
– Remove the bulb, moving it in the direction of the arrow and
⇒ F ig.
outwards
195.
Jump-starting
Jump leads
The jump lead must have a sufficient wire cross section.
If the engine fails to start because of a discharged battery, the battery can
be connected to the battery of another vehicle to start the engine.
Jump leads
Jump leads must comply with standard DIN 72553 (see cable manufactur-
er's instructions). The wire cross section must be at least 25 mm
2
engines and at least 35 mm
for diesel engines.
Note
● The vehicles must not touch each other, otherwise electricity could flow
as soon as the positive terminals are connected.
● The discharged battery must be properly connected to the on-board net-
work.
Practical Tips
If and when
271
2
for petrol
Technical Specifications
Advertisement
Chapters
Table of Contents
