Seat Ibiza Owner's Manual page 69

● Next, accept the connection instructions on the mobile phone.
● When requested, follow the steps to confirm/enter the PIN. If the mobile
requests a PIN to be entered this is 1234, which is the factory setting and
can only be changed at the workshop. Depending on the technology sup-
ported by your mobile the process can vary given that some mobiles only
request confirmation of a request to link to SEAT_BT, while others require
the PIN 1234 to be entered.
● The contacts from the mobile phone's memory and/or SIM card are
transferred to the vehicle system
message asking for confirmation of access to the phone book or other op-
tions, these messages should be accepted in order for the hands free sys-
tem to access the information contained on the mobile and in order to carry
out the complete functions of the system.
● The pairing is complete.
Automatic pairing
When the telephone has been connected and the corresponding user pro-
file created, your telephone will automatically link up with the SEAT tele-
phone system under the following conditions:
● The mobile phone is switched on with the Bluetooth function activated
and the visibility activated. The mobile phone must be close to the vehicle.
● The vehicle system has switched on Bluetooth visible (during the 3 mi-
nutes following activation of the contact or after pressing the button 
"PTT").
● The automatic connection was accepted during the questions of the first
connection.
● The connection to the system has not been deleted in the mobile.
With the ignition switched on, the system searches in the memorised Blue-
tooth devices (user profiles), and if one of these devices is found a connec-
tion attempt is made to connect to the last linked profile that meets the pre-
1)
Depending on the phone model and configuration.
Safety
1)
. Some mobile phones may display a
Operation
viously mentioned requirements. The system will continue connection at-
tempts while there is no connected device.
When a Bluetooth device is connected or when the automatic connection
conditions are met, in order to connect another Bluetooth device, an exist-
ing connection or one that is in the process being connected must be deac-
tivated in advance. In order to do this, deactivate the Bluetooth on the un-
wanted device.
Note
● The visibility of the vehicle's Bluetooth system is switched on for three
minutes when the ignition is switched on with the key. After 3 minutes, if
you need to activate the visibility again, you can do so with the voice control
⇒ p age 68 or turning the ignition off and on again.
● If for any reason you take more than 3 minutes to perform these steps or
more than 30 seconds to enter the PIN, you will have to start the process
over again.
Controls on the multifunction control
Advice
Communications and multimedia
Fig. 45 Multifunction
control buttons.
Technical specifications
67

