Seat Ibiza Owner's Manual page 217

● Remove the tyre sealant bottle from the valve.
● Screw the valve insert again with the corresponding tool
into the tyre valve.
Inflating the tyre
● Securely screw the tyre inflator tube
to the tyre valve.
● Check whether the air bleed screw
● Start the vehicle engine and leave it running.
⇒ F ig. 152
● Attach the connector
⇒ p age 114.
● Connect the air compressor with the ON/OFF switch
● Keep the air compressor running until it reaches 2.0 to 2.5 bar
(29-36 psi / 200-250 kPa) ⇒
● Disconnect the air compressor.
● If it is not possible to achieve an air pressure of 2.0 to 2.5 bar
(29-36 psi / 200-250 kPa), unscrew the tyre inflator tube from the tyre valve.
● Move the vehicle some 10 metres forwards or backwards so that the
sealant is evenly distributed in the tyre interior.
● Securely screw the compressor tyre inflator tube into the tyre valve and
repeat the inflation process.
● If the indicated pressure can still not be reached, the tyre is too badly
damaged. The tyre cannot be sealed with the anti-puncture kit. Do not con-
tinue driving. You should obtain professional assistance ⇒
● Disconnect the air compressor and unscrew the flexible inflator tube
from the tyre valve.
● When the tyre pressure is between 2.5 and 2.0 bars, immediately con-
tinue driving without exceeding 80 km/h (50 mph).
● After 10 minutes, Check the pressure again ⇒ p age 215.
Safety
⇒ F ig. 152
⇒ F ig. 152
of the compressor in-
5
⇒ F ig. 152
is closed.
7
to a 12 volt socket of the vehicle
9
⇒ F ig. 152
. Maximum operation time 8 minutes ⇒ .
.
Operation
WARNING
1
When inflating the wheel, the air compressor and the inflator tube may
become hot.
● Protect hands and skin from hot parts.
● Do not place the hot flexible inflator tube or hot air compressor on
flammable material.
● Allow them to cool before storing the device.
● If it is not possible to inflate the tyre to at least 2.0 bars (29 psi /
200 kPa), the tyre is too badly damaged. The sealant is not in a good con-
dition to seal the tyre. Do not continue driving. Seek specialist assis-
.
8 tance.
CAUTION
Switch off the air compressor after a maximum of 8 operational minutes to
avoid overheating! Before switching on the air compressor again, let it cool
for several minutes.
Check after 10 minutes of driving
Screw the inflator tube
gauge .
6
1.3 bar (19 psi / 130 kPa) and lower:
● Stop the vehicle! The tyre cannot be sealed sufficiently with the tyre mo-
bility set.
● You should obtain professional assistance ⇒
Advice
⇒ F ig. 152
again and check the pressure on the
5
.
Technical specifications
If and when 215

