Table of Contents
Advertisement
240
If and when
Sunroof light
– Carefully remove the light, using the flat side of the screwdriver,
as shown in the illustration
Fig. 171 Removing
sunroof light
Fig. 172 Removing
sunroof light
⇒ fig.
172.
– Remove the lamp, moving it in the direction of the arrow and
⇒ fig.
outwards
172.
– Installation is done in the reverse order.
Jump-starting
Jump leads
The jump lead must have a sufficient wire cross section.
If the engine fails to start because of a discharged battery, the battery can be
connected to the battery of another vehicle to start the engine.
Jump leads
Jump leads must comply with the standard DIN 72553 (see manufacturer's
documentation). The wire cross section must be at least 25 mm
2
engines and at least 35 mm
for diesel engines.
Note
•
The vehicles must not touch each other, otherwise electricity could flow as
soon as the positive terminals are connected.
•
The discharged battery must be properly connected to the vehicles elec-
trical system.
2
for petrol
Advertisement
Table of Contents
