Installing An M.2 Nvme Ssd On The M.2 Ssd/Dedicated Ilo/Serial Port Enablement Board - HP ProLiant DL20 Gen10 User Manual

Installing an M.2 NVMe SSD on the M.2 SSD/dedicated iLO/serial port enablement board

Installing an M.2 NVMe SSD on the M.2 SSD/dedicated iLO/serial port enablement board
NVMe SSDs are directly attached to the PCIe interface and do not have a dedicated hardware RAID engine similar to SAS controllers.
This means that RAID configuration for NVMe SSDs is only supported through the operating system.
IMPORTANT: IMPORTANT:
When installing HPE 400 GB NVMe x4 MU M.2 22110 DS SSD (875583-B21) and HPE 480 GB NVMe x4 RI M.2 22110
DS SSD (875579-001) modules, the supporting ambient temperature should be under 30°C (86°F).
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
T-15 Torx screwdriver
4.5 mm hex nut screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Remove the access panel .
7. Remove the riser cage.
8. Remove the M.2 air guider.
9. Install the M.2 SSD/dedicated iLO/serial port enablement board .
10. Install a hex standoff on the enablement board position corresponding to the type of M.2 SSD to be installed .
Installing an M.2 NVMe SSD on the M.2 SSD/dedicated iLO/serial port enablement board 118