Appendix F. Compliance With Standards - Visonic PowerMaster-360R User Manual

Appendix F. Compliance with standards

European Standards: EN 300220, EN 300328, EN 301489, EN 50130-4, EN 60950-1, 1, EN 50130-5, EN 50131-3, EN
50131-4, EN 50131-6, EN 50136-1, 2, EN 50131-10
According to the European standard EN50131-1 and EN 50131-3, the PowerMaster 360R security grading is 2 - "low to
medium risk" and environmental classification is II – "indoor general". The power supply type is A according to EN
50131-6, built-in siren -type Z warning device according to EN50131-4, and ATS Category is DP4, when IP module
primary path and GPRS secondary, according to EN50136-1, EN50136-2 (pass through Operation Mode) and
according to EN 50131-10 – Supervised Premises Transceiver (SPT).
Certified by Applica T&C in accordance with
EN 50131-1, EN 50131-3, EN 50131-6, EN 50131-5-3, EN 50130-5, EN 50131-4,
EN 50130-4, EN 50131-10, EN 50136-1, EN 50136-2
Applica T&C has certified only the 868 MHz variant of this product.
UK: The PowerMaster-360R is suitable for use in systems installed to conform to PD6662:2010 at Grade 2 and
environmental CLASS II. DD243 and BS8243
Hereby, Visonic Ltd. declares that the radio equipment type PM-360R is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.visonic.com/download-center.
U.S. Standards: (FCC) CFR 47 part 15
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance
(Visonic Ltd.) could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
WARNING! To comply with FCC RF exposure compliance requirements, the device should be located at a
distance of at least 20 cm from all persons during normal operation. The antennas used for this product must not
be co-located or operated in conjunction with any other antenna or transmitter.
66 D-307084 PowerMaster-360R User's Guide