11.
Install the new belt around the mower pulleys
and the clutch pulley under the engine
81).
1. Clutch pulley
2. Mower belt
3. Spring-loaded idler pulley
4. Ratchet
12.
Install the belt guide on the idler arm shown in
Figure
81.
13.
Using the ratchet in the square hole, install the
idler spring
(Figure
Note:
Make sure that the spring ends are
seated in the anchor grooves.
14.
Install the belt covers and the bolts attached to
them
(Figure
82).
Figure 81
5. Square hole in the idler
arm for the ratchet
6. Idler grease fitting
7. Belt guide
81).
(Figure
1. Position the belt cover.
2. Slide belt cover under the
side catches.
Replacing the
Hydraulic-Pump Drive
Belt
g009038
1.
Disengage the blade-control switch (PTO) and
set the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the mower belt; refer to
Mower Belt (page
4.
Raise the machine and support it with jack
stands
57
Figure 82
3. Tighten the bolt.
56).
(Figure
83).
g027730
Replacing the