Figure 35
2500 Series mower deck shown
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 36
1500 and 2000 Series mower deck shown
1. Flange nut
2. Bolt
3. Bushing
g038079
4. Flange nut
5. Bolt
g036848
4. Anti-scalp roller
5. Spacer
Adjusting the Side Bumpers
Rear-Discharge Machines Only
Install the side bumpers in the top holes when
operating in a height of cut higher than 64 mm (2-1/2
inches) and in the center holes when operating in a
height of cut lower than 64 mm (2-1/2 inches).
Note:
When the bumpers become worn, switch the
bumpers to the opposite sides of the mower and flip
them over. This allows you to use the bumpers longer
before replacing them.
1.
Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to
(page
28).
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Raise the mower to the transport position.
4.
Remove the bolts and nuts from each bumper
(Figure
37).
1. Bolt (3)
2. Bumper
5.
Move each bumper to the desired position and
secure them with the bolts and nuts.
Note:
Use only the top or center sets of holes
to adjust the bumpers. You use the bottom
holes when switching sides, at which time they
become the top holes on the other side of the
mower.
35
Engaging the Parking Brake
Figure 37
3. Nut (3)
g037862