Ddr Ii Dimm; Ddr Ii Devices; Qdr Ii Devices - Altera Stratix Memory Board II User Manual

Stratix Memory Board II
1 minute before you get the first timing out message. At this point
just close the GUI.
This finishes the NIOS Stamp section of the tests.

3.3 DDR II DIMM

Set the MPGM switches to 000 (UTILITY SWITCHES 3 – 1 to OPEN). . Press the
RESET (S2) push button. This will load Page 0 from the flash memory. Wait for
LED D13 (CONF_DONE) and LED D15 (USR) to come on.
Press pushbutton S7 (PB3) to reset the design. LED 0 goes on as the S7 is pushed.
When S7 is released the test starts running. User LED 6 should light up, LED 7
starts blinking and the 7 segment display should start counting. LED 0 is the error
indicator. If it goes out the test has failed. The counter will run until the seven
segment display reads 80. At this point if LED 0 is still on the test has passed.

3.4 DDR II devices

Set the MPGM switches to 001 (UTILITY SWITCHES 1 to closed, 2, 3 to OPEN).
Press the RESET (S2) push button. This will load Page 1 from the flash memory.
Wait for LED D13 (CONF_DONE) and LED D15 (USR) to come on.
Press pushbutton S7 (PB3) to reset the design. . LED 0 goes on as the S7 is pushed.
When S7 is released the test starts running. User LED 6 should light up, LED 7
starts blinking and the 7 segment display should start counting. LED 0 is the error
indicator. If it goes out the test has failed. The counter will run until the seven
segment display reads 80. At this point if LED 0 is still on the test has passed.

3.5 QDR II devices

Set the MPGM switches to 010 (UTILITY SWITCHE 2 to closed, 1, 3 to OPEN). .
Press the RESET (S2) push button. This will load Page 2 from the flash memory.
Wait for LED D13 (CONF_DONE) and LED D15 (USR) to come on.
Press pushbutton S7 (PB3) to reset the design. . LED 6 goes on as the S7 is pushed.
When S7 is released the test starts running. User LED 6 should light up and the 7
[lan91c111] nr_lan91c111_reset: chip id = LAN91C111
[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111
internal)
[lan91c111] r_lan91c111_init_phy: phy negotiation timed out
[lan91c111] r_lan91c111_init_phy: 10bt
[lan91c111] r_lan91c111_init_phy: half duplex
[dhcp] 1 timing out
User Guide
9