Setting The Display Turn-Off Time; Password - Yaesu DR-2X Operating Manual

Setting the display turn-off time

1 Touch [ A SETUP ] or [ B SETUP ] , then touch [ F ] , and then touch [ MODE/REMOTE ] .
2 Touch [ DISPLAY TIMER ] to display "ON" or "OFF" .
The set value will change between " OFF " and " ON " each time [ DISPLAY
TIMER ] is touched.
3 Touch [ SETUP ] .
The display timer setting screen will be displayed.
4 Touch [ TIMER ] .
The set value will change in the following sequence each time [ TIMER ] ,
[ ▲ ], or [ ▼ ] is touched (Default 1min).
à "1min" à "5min" à "10min" à "30min" à
5 Touch [ BACK ] 4 times.
The setting is determined and the display will return to the operation mode screen.
z Factory default:
DISPLAY TIMER: ON
TIMER: 1min
z This setting item is common to CH-A and CH-B.

Password

To continue operating the DR-2X/DR-2XE when the power is turned ON or after the display has been turned
OFF, the password must be entered.
z Password is factory set to "0000". It is possible to change the password.
z If you forget your password, you will need to do an all reset. Please note
that when all reset is performed, all settings and memory contents are
returned to the factory default state.
z Use the factory default password "0000", unless it is necessary to change
it for management security.
1 Touch [ A SETUP ] or [ B SETUP ] , then touch [ F ] , and then touch
[ MODE/REMOTE ] .
2 If [ DISPLAY TIMER ] is set to "OFF", touch [ DISPLAY TIMER ] and turn
it to "ON".
3 Touch [ SETUP ] .
4 Touch [ PASSWORD ] twice.
The character input screen will appear.
The touched character will be displayed at the top of the screen.
• Four numeric characters can be entered.
• The cursor in the input field moves left or right when [|  ] or [  |] is
touched.
5 Touch [ BACK ] 4 times.
The setting is determined and the display will return to the operation
mode screen.
z The password input screen will be displayed when the power is turned ON, or after the display has been turned OFF.
Enter the previously registered 4-digit password (default "0000").
z To reset the DR-2X/DR-2XE, press and hold in the [ SETUP ] button while turning the transceiver ON à the password
input screen will appear à press and hold the [ SETUP ] button for 2 seconds à the reset confirmation screen will
appear à touch "OK?".
38
REMOTE/COMMAND/DISP TIMER
REMOTE
COMMAND
DISPLAY TIMER
V / M
BACK
BACK
REMOTE/COMMAND/DISP TIMER
REMOTE
COMMAND
DISPLAY TIMER
V / M
BACK BACK
PASSWORD
DR-2X / DR-2XE Operating Manual
OFF
>
ON
OFF
>
ON
123
Space
ENT