Change The Remote Command - Yaesu DR-2X Operating Manual

Change the remote command

To change the factory command codes.
1 Touch [ A SETUP ] or [ B SETUP ] on the operation mode screen.
The setup mode screen will appear.
2 Touch [ F ] on the setup mode screen.
The setup menu will appear.
3 Touch [ MODE/REMOTE ] .
The menu list will appear.
[ COMMAND ] twice.
4
Touch
The command list will appear.
5 Touch [ t u ] to select the desired CONTROL MODE (DIGITAL or
DTMF).
6 Touch [ ▲ ] or [ ▼ ] to select the desired command.
7 Touch the command to enable setting the remote control code.
8 Enter a 4-digit control code.
The screen returns to the command list.
The same code as another function may not be set.
9 Touch [ BACK ] 4 times.
The screen returns to the operation mode screen.
28
R - O FF
T - O F F
REMOTE/COMMAND/DISP TIMER
REMOTE
COMMAND
DISPLAY TIMER
V / M
BACK
BACK
C O N T R O L M O D E
A C T I V A T E
D E A C T I V A T E ( L O C A L )
D E A C T I V A T E ( A L L )
F I X D I G I T A L
ACTIVATE
1
DR-2X / DR-2XE Operating Manual
 8 4  
D G - I D
OFF
>
ON
D I G I T A L
* 1 1 1 1
* 2 2 2 2
* 2 2 2 1
* 3 3 3 3
*1111
3
Space
ENT