Set Up Operation Mode - Yaesu DR-2X Operating Manual

2. Set up Operation Mode

When the Power Switch is turned ON, Operation Mode screen appears.
This screen is for normal operation.
The DR-2X/DR-2XE could be set up with two frequencies for the uplink and the downlink and also different
operation modes for each frequency.
Normal Dual CH Operation
In Normal Duel Channel Operation, the DR-2X/DR-2XE accepts the uplink channel on a first come basis, and
the later signal on the other channel is not repeated until the first channel is released.
Priority Dual CH Operation
In Priority Dual Channel Operation, the DR-2X/DR-2XE always repeats the Priority Channel, regardless of any
signals on the other channel (see page 13 "Priority Channel").
To setup priority CH, touch the area between RX and TX on the channel you want to set the priority channel.
To reset, touch the area again.
Single CH Operation
If you do not need the second CH on DR-2X/DR-2XE, just enter any frequency on CH-B and do not connect
the uplink antenna to RX ANT B.
CH-B can be used exclusively for repeater control without any repeater operation. In this case, the downlink
frequency of CH-B is not displayed.
To setup CH-B for control only, touch the area between RX and TX on the CH-B until CNTL appears.
To reset, touch the area again.
CH - A
CH - B
To receive Analog FM and Digital C4FM signals simultaneously, set RX to [ AUTO ] mode.
This mode may activate the AMS (Automatic Mode Select) function, then receive (uplink) and transmit
(downlink) signals of the Analog FM and Digital C4FM. The default setting is [ AUTO ] .
If operating the repeater using the DG-ID and connecting multiple repeaters, select the [ DIGITAL ] in the [ FIX ]
mode. The DG-ID function is not available because the Analog FM mode does not include the DG-ID information.
In the C4FM digital mode, three digital modes are recognized automatically. In normal C4FM digital, it will be
in V/D mode.
Touch [ AUTO ] or [ FIX ] in the operation mode screen area to set the operating mode.
[ AUTO ] Touch here to activate the AMS function. The mode switches automatically according to the
received/transmitted signal types. [ AUTO ] is turned red, [ DIGITAL ] automatically light up.
[ FIX ] Touch here to activate the FIX mode. [ FIX ] is turned yellow. Note that when selecting the [FIX]
mode, that other mode signals may not be received.
Either [ VOICE WIDE ] or [ DATA ] modes are automatically recognized in the C4FM uplink Signal, and receive
mode is changed to fit the signals, so no setting is necessary. [ FIX FM ] cannot be selected.
[ DIGITAL ]
[ VOICE WIDE ]
[ DATA ]
[ FM ]
10










Normal C4FM digital mode
High-rate voice C4FM digital mode
High-speed data C4FM digital mode
Analog FM communication mode (AUTO mode only)
RX ( uplink )
TX ( downlink )
RX ( uplink )
TX ( downlink )
DR-2X / DR-2XE Operating Manual