Setting The Display Turn-On Time; Setting The Packet Speed - Yaesu DR-1 Operating Manual

Setting the display turn-on time

1
Touch [F] in the setup mode screen
The setup menu will appear.
2
Touch [MODE/REMOTE]
The menu list will appear.
3
Select [DISPLAY TIMER]
4
Touch [DISPLAY TIMER]
The set value will change in the following sequence each time it is touched.
"CONTINUE" → "1min" → "5min" → "10min" → "30min"
Tip Factory default: CONTINUE
5
Touch [BACK]
The setting is determined and the display will return to the menu list.

Setting the Packet Speed

1
Touch [F] in the setup mode screen
The setup menu will appear.
2
Touch the RX band area.
The set value will change between [1200 bps] and [9600 bps] each time it is touched.
Tip Factory default: 1200 bps
3
Three seconds after selecting the packet speed, the new setting is automatically
saved and the display will return to the menu list.
Setting up the Repeater
33