Initial Set Up; Turn The Power On; Set Up The Id (Call Sign) - Yaesu DR-2X Operating Manual

1. Initial set up

Turn the power on

1
Press the POWER switch.
The power will be switched ON, and the power supply monitor
(LED indicator) will illuminate.
z When the power is supplied from the AC IN jack, the indicator
illuminates in green (DR-2X only).
z When the power is supplied through the BACKUP terminals / DC
IN terminal (13.8V DC), the indicator illuminates in red.
The operation mode screen will appear on the display.

Set up the ID (call sign)

The call sign or ID must be entered for the first time after purchasing, or after resetting the repeater.
After performing a factory reset, the ID call sign setup begins with 2.
1 Touch [ A SETUP ] or [ B SETUP ] to display Frequency screen.
2 Touch [ F ] to display the Function screen pops up.
3 Touch ID set area.
The character input screen will appear.
4 Touch a character key.
The touched character will be displayed at the top of the screen.
z Each time [
erase one character.
z The input screen changes between numbers input and alphabet
input each time [ ABC ] is touched.
z The cursor in the input field moves left or right when [|  ] or [  |]
are touched.
z Up to 10 alphabet characters, numbers, or the hyphen can be entered.
5 Touch [ ENT ] .
The ID setting is saved and the display will return to the Function
screen.
DR-2X / DR-2XE Operating Manual
] is touched the cursor will move to the left and
 8 4  
 3 4  
 8 4  
D G - I D
R - O FF
T - O F F
ID SET W 6 D X C
Q W E R T Y U I O P
-
A S D F G H J K L
Caps Z X C V B N M
  
ABC Space
#%^
ENT
9