Setting The Sql Hysteresis; Setting The Sql Tail Length - Yaesu DR-2X Operating Manual

Set announcement time interval
1 Touch [ A SETUP ] or [ B SETUP ] , then touch [ F ] .
2 Touch [ ID ANNOUNCE ] , then touch [ INTERVAL ] .
The set value will change in the following sequence each time [ INTERVAL ],
[ ▲ ], or [ ▼ ] is touched.
à "OFF" à "3min" à "5min" à "10min" à
3 Touch [ BACK ] 3 times .
The setting is determined and the display will return to the operation
mode screen.
z Factory default: 10min
z This setting item is common to CH-A and CH-B.
z When "CW wo TONE" or "VC wo TONE" on "ANNOUNCE MODE" is set, the time interval is fixed at 10 minutes.
z When operating in the USA, the ID setting time should be ten minutes or less to comply with the FCC rule Part 97:
Sec. 97.119 (a) Station identification.

Setting the SQL HYSTERESIS

1 Touch [ A SETUP ] or [ B SETUP ] , then touch [ F ] , and then touch [ TIMER ] .
2 Touch [ SQL ] twice.
3 Touch [ SQL HYSTERESIS ] .
The set value will change in the following sequence each time [ SQL
HYSTERESIS ] , [ ▲ ], or [ ▼ ] is touched.
à "NORMAL" à "HIGH" à "MAX" à
4 Touch [ BACK ] 4 times .
The setting is determined and the display will return to the operation
mode screen.
z Factory default: NORMAL
z This setting item is common to CH-A and CH-B.

Setting the SQL TAIL LENGTH

1 Touch [ A SETUP ] or [ B SETUP ] , then touch [ F ] , and then touch [ TIMER ] .
2 Touch [ SQL ] twice.
3 Touch [ SQL TAIL LENGTH ] .
The set value will change in the following sequence each time [ SQL TAIL
LENGTH ] , [ ▲ ], or [ ▼ ] is touched.
à "0ms" à "50ms" à "100ms" à ..................... à "2500ms" à
4 Touch [ BACK ] 4 times.
The setting is determined and the display will return to the operation
mode screen.
z Factory default: 0ms
z This setting item is common to CH-A and CH-B.
DR-2X / DR-2XE Operating Manual
à "15min" à "20min" à "30min" à "TOT" à
 8 4  
D G - I D
R - O FF
T - O F F
 8 4  
D G - I D
R - O FF
T - O F F
 8 4  
D G - I D
R - O FF
T - O F F
37