Connecting Antenna Cables; Select Downlink Antenna - Yaesu DR-2X Operating Manual

Connecting Antenna Cables

The figure above shows the rear panel of the DR-2X.
1 When using a duplexer, plug the coaxial cables from the TX ANT and RX ANT terminals into the jacks of the
duplexer, and tighten the connectors.
2 Plug in the terminal of the coaxial cable connected to the antenna into the jack of the duplexer, and turn to
tighten.

Select downlink antenna

Normally, the CH-A downlink outputs to the CH-A TX Antenna Terminal and the CH-B downlink outputs to CH-B
TX Antenna Terminal. Both CH-A and CH-B downlinks may be output to the CH-A TX Antenna Terminal.
This setting allows operating both downlinks with the same antenna.
By pressing and holding "DOWNLINK" in the CH-B frequency set up screen, "DOWNLINK" will be changed to
"DOWNLINK TO ANT A" and the CH-B downlink signal will be output to CH-A (see page 12).
4
From TX ANT
From RX ANT
To antenna
Duplexer
DR-2X / DR-2XE Operating Manual