Advertisement
Repeater setting
If an HRI-200 control mode repeater is connected, the following repeater setting screen for exclusive use of
Repeater is displayed.
• When an HRI-200 control mode repeater is detected, the setting information is read from the Repeater and
is displayed on the screen.
• If connecting an HRI-200 control mode repeater, switch on the DR-1X/XE unit while simultaneously pressing
the mechanical [ SETUP ] button on the front panel. When the "YAESU" logo is displayed on the LCD touch
screen, release the [ SETUP ] button, the LCD will change to "HRI-REPEATER MODE". Then press the [ OK ]
button.
• If operating in Analog FM mode while connected to an HRI-200 control mode repeater, noise squelch can be
adjusted by pressing the [ SQL ] button (setup screen) and touching the [ p ] / [ q ] button.
Voice CH
Voice CH uses WIRES-X to communicate via the Internet.
Operation will be executed by controlling the repeater connected to the HRI-200 Radio 1 terminal.
The following parameters need to be set/display for operation.
WIRES Operation
Select a WIRES operation mode from the following options:
• Digital : C4FM digital mode.
• Analog : FM Analog mode.
Note
• The WIRES Operation is automatically set according to TX CH parameters (Transceiver) setting of the
Repeater. However, if the transmit CH is AMS, the WIRES Operation setting must be selected.
• When the Repeater is connected, you cannot operate the Digital Dual Receive mode.
• You cannot selected GM mode or connect to a closed room while in Analog (FM) operation.
3
Advertisement
