Setting The Half Deviation Operation; Setting The Tone Signals For Analog Fm Mode - Yaesu DR-2X Operating Manual

Setting the half deviation operation

1 Touch [ A SETUP ] or [ B SETUP ] , and then touch [ F ] .
2 Touch [ DEVIATION ] to display "NARROW".
The setting will toggle between "NARROW" and "WIDE" each time
[ DEVIATION ] is touched.
NARROW: Reduces the analog FM/C4FM digital modulation to half.
WIDE: Uses the normal analog FM/C4FM digital modulation.
3 Touch [ BACK ] twice.
The setting is determined and the display will return to the operation
mode screen.
z Factory default: WIDE
z This setting item may be set on CH-A and CH-B individually.

Setting the tone signals for analog FM mode

Setting the tone frequency
1 Touch [ A SETUP ] or [ B SETUP ] , then touch [ F ] .
2 Touch [ SIGNALING ] .
3 Touch [ ◄ ► ] to select the "RX TONE FREQ" and the "TX TONE FREQ".
4 Touch [ ▲ ] or [ ▼ ] .
The set value will change each time [ ▲ ] or [ ▼ ] is touched.
5 Touch [ BACK ] 3 times.
The setting is determined and the display will return to the operation
mode screen.
z Factory default: 100.0 Hz
z Tone frequencies between 67.0 Hz and 254.1 Hz can be selected.
z Both TX and RX can be set to different Tone frequency.
z This item may be set separately on the CH-A and CH-B.
Setting the DCS code
1 Touch [ A SETUP ] or [ B SETUP ] , then touch [ F ] .
2 Touch [ SIGNALING ] , then touch [ DCS CODE ] .
3 Touch [ ◄ ► ] to select the "RX DCS CODE" and the "TX DCS CODE".
4 Touch [ ▲ ] or [ ▼ ] .
The set value will change each time [ ▲ ] or [ ▼ ] is touched.
5 Touch [ BACK ] 3 times.
The setting is determined and the display will return to the operation
mode screen.
z Factory default: 023
z DCS codes between 023 and 754 can be selected.
z Each TX and RX can be set to different code.
z This setting item may be set on the CH-A and CH-B individually.
DR-2X / DR-2XE Operating Manual
 8 4  
D G - I D
R - O FF
T - O F F
 8 4  
D G - I D
R - O FF
T - O F F
 8 4  
D G - I D
R - O FF
T - O F F
35