Installation And Connection; Setting Up The Repeater; Safety Measures For Installation; Installing The Repeater - Yaesu DR-1 Operating Manual

Setting up the Repeater

Safety measures for installation

Note the followings precautions when installing this repeater.
 Use good engineering, proper grounding and protective devices to protect the repeater from power surges, lightening and electrical
damage via the power and external antenna connections.
 Do not install the repeater in a place where there is extreme vibration, where there is a lot of dust, excessive humidity or high
temperature, or where it is exposed to direct sunlight.
 Install the repeater in a well ventilated position, so heat dissipation is not obstructed. The heat sink becomes hot when transmitting
for long periods of time.
 Do not place any objects on top of the repeater.
 Note that there is a risk that hum and noise may be introduced, depending on the installation conditions and the external power
source used.
 Install the repeater as far as possible away from TV and radio equipment to avoid (TVI, BCI).
In particular, do not install the repeater near indoor antenna elements.

Installing the repeater

Place the repeater on a flat and level rack or shelf, with its bottom side down.
We recommend securing the wings of the repeater front panel to the equipment rack or shelf with bolts.

Mounting on a desk

When using the repeater in a desktop location instead of a rack or shelf, attach the four supplied legs onto the bottom of the repeater
case.

Installation and Connection

11