Static-Bind Prefix - HP A5120 EI Series Command Reference Manual

Description
Use the sip-server command to configure the IPv6 address or domain name of a SIP server for the client.
Use the undo sip-server command to remove the configuration.
No SIP server address or domain name is specified by default.
You can configure up to eight SIP server addresses and eight SIP server domain names in an address
pool. The priorities of the specified SIP servers depend on the configuration sequence. The formerly
specified SIP server takes precedence over the latter one.
If you repeatedly use the sip-server command, the last configuration does not overwrite the previous one.
Examples
# Specify the SIP server address as 2:2::4 for the client.
<Sysname> system-view
[Sysname] ipv6 dhcp pool 1
[Sysname-dhcp6-pool-1] sip-server address 2:2::4
# Specify the domain name of the SIP server as bbb.com for the client.
[Sysname-dhcp6-pool-1] sip-server domain-name bbb.com

static-bind prefix

Syntax
static-bind prefix prefix/prefix-len duid duid [ iaid iaid ] [ preferred-lifetime preferred-lifetime valid-
lifetime valid-lifetime ]
undo static-bind prefix prefix/prefix-len
View
DHCPv6 address pool view
Default level
2: System level
Parameters
prefix/prefix-len: Specifies the static prefix and prefix length.
duid duid: Client DUID. The value is an even hexadecimal number, in the range 2 to 256.
iaid iaid: Client IAID. The value is a hexadecimal number in the range 0 to FFFFFFFF. If no IAID is
specified, the server does not match against the client IAID for prefix assignment.
preferred-lifetime preferred-lifetime: Specifies the preferred lifetime of the prefix to be assigned. The value
ranges from 60 to 4,294,967,295, in seconds. The default value is 604,800 seconds, that is, seven days.
valid-lifetime valid-lifetime: Specifies the valid lifetime of the prefix to be assigned. The value ranges from
60 to 4,294,967,295, in seconds. The default value is 2,592,000 seconds, that is, 30 days. The valid
lifetime must be greater than or equal to the preferred lifetime.
Description
Use the static-bind prefix command to configure a static prefix.
Use the undo static-bind prefix command to remove a static prefix.
No static prefix is configured by default.
197