Dhcp-Snooping Information Circuit-Id Format-Type; Dhcp-Snooping Information Circuit-Id String - HP A5120 EI Series Command Reference Manual

[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dhcp-snooping check request-message

dhcp-snooping information circuit-id format-type

Syntax
dhcp-snooping information circuit-id format-type { ascii | hex }
undo dhcp-snooping information circuit-id format-type
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
ascii: Specifies the code type for the circuit ID sub-option as ascii.
hex: Specifies the code type for the circuit ID sub-option as hex.
Description
Use the dhcp-snooping information circuit-id format-type command to configure the code type for the
non-user-defined circuit ID sub-option.
Use the undo dhcp-snooping information circuit-id format-type command to restore the default.
By default, the code type for the circuit ID sub-option depends on the padding format of Option 82. Each
field has its own code type.
This command applies to configuring the non-user-defined circuit ID sub-option only. After you configure
the padding content for the circuit ID sub-option using the dhcp-snooping information circuit-id string
command, ASCII is adopted as the code type.
Related commands: display dhcp-snooping information.
Examples
# Configure the padding format for the non-user-defined circuit ID sub-option as ascii.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dhcp-snooping information circuit-id format-type ascii

dhcp-snooping information circuit-id string

Syntax
dhcp-snooping information [ vlan vlan-id ] circuit-id string circuit-id
undo dhcp-snooping information [ vlan vlan-id ] circuit-id string
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
80