Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure the graft retry timer.
Configuring PIM-SM
This section describes how to configure PIM-SM.
PIM-SM configuration task list
Task at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
•
(Optional.)
NOTE:
You must configure a static RP, a C-RP, or both in a PIM-SM domain.
In a network without C-RPs, skip the task of configuring a BSR.
Configure a BSR:
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Configuration prerequisites
Before you configure PIM-SM, configure a unicast routing protocol so that all devices in the domain are
interoperable at the network layer.
Enabling PIM-SM
Enable IP multicast routing before you configure PIM.
With PIM-SM enabled on interfaces, routers can establish PIM neighbor relationship and process PIM
messages from their PIM neighbors. When you deploy a PIM-SM domain, HP recommends that you
enable PIM-SM on all non-border interfaces.
Enabling PIM-SM
Configuring an
RP:
Configuring Anycast RP
Configuring a C-BSR
Configuring a PIM domain border
Disabling the BSM semantic fragmentation function
Configuring multicast source registration
Configuring switchover to SPT
Configuring common PIM features
Command
system-view
interface interface-type
interface-number
pim timer graft-retry interval
96
Remarks
N/A
N/A
The default setting is 3 seconds.