Reassigning An Automatically Assigned Port Number - Hitachi VSP G200 System Administration Manual

3.
4.
5.
6.

Reassigning an automatically assigned port number

You can reassign the port number that is automatically assigned to the
storage system.
If the port number assigned to the storage system is used in another
application, the port number is reassigned. Also, if you disabled the
automatic assign, this deletes the unnecessary port number that is already
assigned.
Caution:
• Stop the storage system service before reassigning. If you did not stop
• The port for DeviceJettyStart and DeviceJettyStop that is assigned when
• If you disable the function which is using the port, this deletes the port
Procedure
1.
2.
3.
4.
132
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
In the folder where the .bat file is located, execute the following
command:
C:\MAPP\wk\Supervisor\MappIniSet>MappSetPortInit.bat
An initialization confirmation message box displays.
If you want to continue, enter Y, and then press the Enter key. If you
want to cancel the task, enter N, and then press the Enter key.
A service restart message box displays, followed by a completion
message box. Press any key to acknowledge the message and close the
message box.
Close the Windows command prompt.
before reassigning, stop the storage system service in Storage Device List
window, then start the service.
starting the storage system service cannot be reassigned.
number that is already assigned.
Logout from Device Manager - Storage Navigator on the storage system
that you want to reassign.
Stop the service of the storage system that you want to reassign.
Open the Windows command prompt as administrator on the SVP.
In the folder where the .bat file is located, execute the following
command:
C:\MAPP\wk\Supervisor\MappIniSet>MappPortManageRenum.bat serial-
number (optional)
Note: A space is required between MappPortManageRenum.bat
and serial-number.
Configuring the storage system