Brocade Communications Systems FastIron SX 800 Configuration Manual page 316

Configuring OSPFv3
The key variable must be 40 hexadecimal characters. To change an existing key, you must also specify a different SPI value. You cannot
just change the key without also specifying a different SPI, too. For example, in an interface context where you intend to change a key,
you must type a different SPI value -- which occurs before the key parameter on the command line -- before you type the new key.
If no-encrypt is not entered, then the key will be encrypted. This is the default. The system adds the following in the configuration to
indicate that the key is encrypted:
• encrypt = the key string uses proprietary simple cryptographic 2-way algorithm
• encryptb64 = the key string uses proprietary base64 cryptographic 2-way algorithm
This example results in the configuration shown in the screen output that follows. Note that because the optional no-encrypt keyword
was omitted, the display of the key has the encrypted form by default.
interface ethernet 1/1/2
enable
ip address 10.3.3.1/8
ipv6 address 2001:db8:3::1/64
ipv6 ospf area 1
ipv6 ospf authentication ipsec spi 429496795 esp sha1 encryptb64 $ITJkQG5HWnw4M09tWVd
Configuring IPsec for an area
This application of the area command (for IPsec) applies to all of the interfaces that belong to an area unless an interface has its own
IPsec configuration. The interface IPsec can be operationally disabled if necessary.) To configure IPsec for an area in the IPv6 router
OSPF context, proceed as in the following example.
device(config-ospf6-router)# area 2 auth ipsec spi 400 esp sha1 abcef12345678901234fedcba098765432109876
Syntax: [no] area area-id authentication ipsec spi spi-num esp sha1 [no-encrypt] key
The no form of this command deletes IPsec from the area.
The area command and the area-id variable specify the area for this IPsec configuration. The area-id can be an integer in the range 0
through 2,147,483,647 or have the format of an IP address.
The authentication keyword specifies that the function to specify for the area is packet authentication.
The ipsec keyword specifies that IPsec is the protocol that authenticates the packets.
The spi keyword and the spi-num variable specify the index that points to the security association. The near-end and far-end values for
spi-num must be the same. The range for spi-num is decimal 256 through 4294967295.
The mandatory esp keyword specifies ESP (rather than authentication header) as the protocol to provide packet-level security. In the
current release, this parameter can be esp only.
The sha1 keyword specifies the HMAC-SHA1-96 authentication algorithm. This mandatory parameter can be only the sha1 keyword in
the current release.
Including the optional no-encrypt keyword means that the 40-character key is not encrypted upon either its entry or its display. The key
must be 40 hexadecimal characters.
If no-encrypt is not entered, then the key will be encrypted. This is the default. The system adds the following in the configuration to
indicate that the key is encrypted:
• encrypt = the key string uses proprietary simple cryptographic 2-way algorithm
• encryptb64 = the key string uses proprietary base64 cryptographic 2-way algorithm
The configuration in the preceding example results in the configuration for area 2 that is illustrated in the following.
ipv6 router ospf
area 0
area 1
316
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04