Brocade Communications Systems FastIron SX 800 Configuration Manual page 328

Displaying OSPFv3 information
Hello 739
DbDesc 2
LSReq 1
LSUpdate 344
LSAck 30
OSPF messages dropped,no authentication: 0
ve 17 admin up, oper up, IPv6 enabled
IPv6 Address:
fe80::214:ff:fe77:96ff
5100::192:213:111:213/112
5100::192:213:111:0/112
Instance ID 0, Router ID 192.168.98.213
Area ID 0.0.0.200, Cost 1, Type BROADCAST
MTU: 10178
State BDR, Transmit Delay 1 sec, Priority 1, Link-LSA Tx not suppressed
Timer intervals :
Hello 10, Hello Jitter 10
Authentication Use: Enabled
KeyRolloverTime(sec): Configured: 300 Current: 0
KeyRolloverState: NotActive
Outbound: None
Inbound: None
DR:192.168.98.111 BDR:192.168.98.213
DRElection:
Neighbor Count = 1,
Neighbor:
192.168.98.111 (DR)
Statistics of interface ve 17 :
Type tx
You can display detailed OSPFv3 information about a specific interface using the following command at any level of the CLI.
Syntax: show ipv6 ospf interface [ brief ] [ ethernet unit/slot/port ] [ loopback number ] [tunnel number ] [ ve number ]
The ethernet, loopback , tunnel, and ve parameter specify the interface for which to display information. If you specify an Ethernet
interface, also specify the port number associated with the interface. If you specify a loopback, tunnel, or VE interface, also specify the
number associated with the interface.
TABLE 75 show ipv6 ospf interface output descriptions
This field
Interface status
Type
IPv6 Address
Instance ID
Router ID
Area ID
Cost
default
328
738 29556
2 236
1 1444
258 71464
291 6780
Dead 40, Retransmit 5
1 times, DelayedLSAck:
Adjacent Neighbor Count= 1
rx tx-byte
29520
2536
88
23256
11396
Number of I/F scoped LSAs is 2
7 times
rx-byte
Displays
The status of the interface. Possible status includes the following:
• Up.
• Down.
The type of OSPFv3 circuit running on the interface. Possible types
include the following:
• BROADCAST
• POINT TO POINT UNKNOWN
• POINT TO POINT
The IPv6 address assigned to the interface.
An identifier for an instance of OSPFv3.
The IPv4 address of the device. By default, the router ID is the IPv4
address configured on the lowest numbered loopback interface. If the
device does not have a loopback interface, the default router ID is the
lowest numbered IPv4 address configured on the device.
The IPv4 address or numerical value of the area in which the interface
belongs.
The overhead required to send a packet through the interface.
Shows whether or not the default passive state is set.
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04