Enable Ospf On The Device - Brocade Communications Systems FastIron SX 800 Configuration Manual

• Define the area virtual link.
• Set global default metric for OSPF.
• Change the reference bandwidth for the default cost of OSPF interfaces.
• Disable or re-enable load sharing.
• Enable or disable default-information-originate.
• Modify Shortest Path First (SPF) timers
• Define external route summarization
• Define redistribution metric type.
• Define redistribution route maps.
• Enable redistribution.
• Change the LSA pacing interval.
• Modify OSPF Traps generated.
• Modify database overflow interval.
• Stub Router advertisement
• Set all the OSPFv2 interfaces to the passive state.
Interface parameters
The interface OSPF parameters are as follows:
• Assign interfaces to an area.
• Define the authentication key for the interface.
• Change the authentication-change interval
• Modify the cost for a link.
• Modify the dead interval.
• Modify MD5 authentication key parameters.
• Modify the priority of the interface.
• Modify the retransmit interval for the interface.
• Modify the transit delay of the interface.
NOTE
You set global level parameters at the OSPF CONFIG Level of the CLI. To reach that level, enter router ospf at the global
CONFIG Level. Interface parameters for OSPF are set at the interface CONFIG Level using the CLI command ip ospf.
When using the Web Management Interface, you set OSPF global parameters using the OSPF configuration panel. All other parameters
are accessed through links accessed from the OSPF configuration sheet.

Enable OSPF on the device

When you enable OSPF on the device, the protocol is automatically activated. To enable OSPF on the device, use the following method.
device(config)# router ospf
device(config-ospf-router)#
This command launches you into the OSPF router level where you can assign areas and modify OSPF global parameters.
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04
Configuring OSPF
233