Displaying Vrrp And Vrrp-E Information - Brocade Communications Systems FastIron SX 800 Configuration Manual

Displaying VRRP and VRRP-E information

9. Verify that accept mode is enabled.
device# show ip vrrp vrid 1
Interface 1/1/5
----------------
auth-type no authentication
VRID 1 (index 1)
interface 1/1/5
state master
administrative-status enabled
version v2
mode non-owner (backup)
virtual mac aaaa.bbbb.cccc (configured)
priority 110
current priority 110
track-priority 2
hello-interval 1 sec
accept-mdoe enabled
.
.
.
The following example enables accept mode for a VRRP backup device.
device# configure terminal
device(config)# router vrrp
device(config)# interface ethernet 1/1/5
device(conf-if-e1000-1/1/5)# ip address 10.53.5.3/24
device(conf-if-e1000-1/1/5)# ip vrrp vrid 1
device(conf-if-e1000-1/1/5-vrid-1)# backup priority 110
device(conf-if-e1000-1/1/5-vrid-1)# accept-mode
Displaying VRRP and VRRP-E information
You can display the following information for VRRP or VRRP-E:
• Summary configuration and status information
• Detailed configuration and status information
• VRRP and VRRP-E statistics
Syntax for IPv4 and IPv6 VRRP:
Syntax: show ip vrrp [ brief | [ stat | [ statistics ] [ vrid num ] ] [ ethernet unit/slotnum/portnum | ve num ] ]
Syntax: show ipv6 vrrp [ brief | [ stat | [ statistics ] [ vrid num ] ] [ ethernet unit/slotnum/portnum | ve num ] ]
Syntax for IPv4 and IPv6 VRRP-E:
Syntax: show ip vrrp-extended [ brief | [ stat | [ statistics ] [ vrid num ] ] [ ethernet unit/slotnum/portnum | ve num ] ]
Syntax: show ipv6 vrrp-extended [ brief | [ stat | [ statistics ] [ vrid num ] ] [ ethernet unit/slotnum/portnum | ve num ] ]
The brief option displays the summary information. If you do not use this option, detailed information is displayed instead.
The ethernet unit/slotnum/portnum option displays VRRP or VRRP-E information only for the specified interface.
The ve num option specifies a virtual interface. If you use this option, the command displays VRRP or VRRP-E information only for the
specified virtual interface.
The stat option displays statistics.
The statistics option displays a summary of key statistics.
542
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04