FIGURE 24 Redistributing OSPF and static routes to RIP routes
You also have the option of specifying import of just RIP, OSPF, BGP4, or static routes, as well as specifying that only routes for a
specific network or with a specific cost (metric) be imported, as shown in the command syntax below.
Syntax: [no] redistribute { bgp | connected | rip | static [ route-map map-name ] }
NOTE
Prior to software release 04.1.00, the redistribution command is used instead of redistribute .
For example, to enable redistribution of RIP and static IP routes into OSPF, enter the following commands.
device(config)# router ospf
device(config-ospf-router)# redistribute rip
device(config-ospf-router)# redistribute static
device(config-ospf-router)# write memory
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04
Configuring OSPF
249