Displaying Ospf Information; Displaying General Ospf Configuration Information - Brocade Communications Systems FastIron SX 800 Configuration Manual

Displaying OSPF Router Advertisement
Using the show ip ospf command you can display the current OSPF Router Advertisement configuration.
device# show ip ospf
OSPF Version
Router Id
ASBR Status
ABR Status
Redistribute Ext Routes from
Initial SPF schedule delay
Minimum hold time for SPFs
Maximum hold time for SPFs
External LSA Counter
External LSA Checksum Sum
Originate New LSA Counter
Rx New LSA Counter
External LSA Limit
Database Overflow Interval
Database Overflow State :
RFC 1583 Compatibility :
NSSA Translator:
Nonstop Routing:
Graceful Restart:
Graceful Restart Helper:

Displaying OSPF information

You can use CLI commands and Web management options to display the following OSPF information:
• Trap, area, and interface information
• CPU utilization statistics
• Area information
• Neighbor information
• Interface information
• Route information
• External link state information
• Database Information
• Link state information
• Virtual Neighbor information
• Virtual Link information
• ABR and ASBR information
• Trap state information
• OSPF Point-to-Point Links
• OSPF Graceful Restart information
• OSPF Router Advertisement information

Displaying general OSPF configuration information

To display general OSPF configuration information, enter the following command at any CLI level.
device# show ip ospf config
Router OSPF: Enabled
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04
Version 2
192.168.98.213
Yes
Yes (1)
Connected RIP
0 (msecs)
0 (msecs)
0 (msecs)
2
000104fc
737
1591
6990506
0
NOT OVERFLOWED
Enabled
Enabled
Disabled
Enabled, timer 120
Enabled O 35m5s

Displaying OSPF information

271