Brocade Communications Systems FastIron SX 800 Configuration Manual page 501

2. Enter the show ipv6 bgp attribute-entries command.
device# show ipv6 bgp attribute-entries
Total number of BGP Attribute Entries: 2
1 Next Hop
Originator:0.0.0.0
Aggregator:AS Number :0
Local Pref:1
AS Path
Address: 0x1205c75c
Links: 0x00000000, 0x00000000
Reference Counts: 2:0:0, Magic: 1
2 Next Hop
Originator:0.0.0.0
Aggregator:AS Number :0
Local Pref:100
AS Path
Address: 0x1205c7cc
Links: 0x00000000, 0x00000000
Reference Counts: 1:0:1, Magic: 2
This example shows information about two route-attribute entries that are stored in device memory.
3. Enter the show ipv6 bgp peer-group command.
device# show ipv6 bgp peer-group
1 BGP peer-group is P1, Remote AS: 1
Address family : IPV4 Unicast
activate
Address family : IPV4 Multicast
no activate
Address family : IPV6 Unicast
activate
Address family : IPV6 Multicast
no activate
Address family : VPNV4 Unicast
no activate
Address family : L2VPN VPLS
no activate
Members:
IP Address: 2001::1
IP Address: 2001:0:0:1::1
IP Address: 10.1.0.1
This example shows output for a peer group called "P1".
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04
: 2001::1
: (length 0)
Hash:268 (0x01000000)
: ::
: (length 0)
AsPathLen: 0 AsNum: 0, SegmentNum: 0, Neighboring As: 0, Source As 0
Hash:365 (0x01000000)
Cluster List:None
Router-ID:0.0.0.0
Communities:Internet
Cluster List:None
Router-ID:0.0.0.0
Communities:Internet
MED :1
Atomic:None
MED :1
Atomic:None
Configuring BGP4+
Origin:IGP
Origin:IGP
501