Displaying Ipv6 Ospfv3 Interface Information - Brocade Communications Systems FastIron SX 800 Configuration Manual

Hide thumbs Also See for FastIron SX 800:
Table of Contents

Advertisement

Displaying OSPFv3 information
TABLE 73 show ipv6 interface output descriptions
Field
Type Codes
Interface
Stat/Port
IGPs
IPv6 Address
VRF

Displaying IPv6 OSPFv3 interface information

IPv6 Interface information can be displayed in either a brief or full mode. The following sections describe the command to display these
modes and the resulting output:
Displaying IPv6 OSPFv3 Interface Information in Brief Mode
Displaying IPv6 OSPFv3 Interface Information in Full Mode
Displaying IPv6 OSPFv3 interface information in brief mode
You can use the following command to display a summary of IPv6 Interface information.
device# show ipv6 ospf interface brief
Interface
Area
eth 1/1/1
0
loopback 1 0
Syntax: show ipv6 ospf interface brief
TABLE 74 show ipv6 ospf interface brief output descriptions
This field
Number of Interfaces
Interface
Area
Status
Type
326
Status
Type Cost
State
up
BCST 1
DROther
up
BCST 1
Loopback
Description
Shows the routing protocol enabled on the interface. The routing protocol
can be one of the following:
R - RIP
O - OSPF
Shows the type, unit, slot, and port number of the interface.
Shows the status of the link and the protocol for the interface. The status
can be one of the following:
Up
Down
Shows the type of the Interior Gateway Protocols (IGPs) enabled on the
interface.
Shows the link local IPv6 address configured for the interface.
Specifies the VRF to which the interface belongs.
Nbrs (F/C)
1/1
0/0
Displays
Number of OSPFv3-enabled interfaces.
The interface type, and the unit, slot, and port number or number of the
interface.
The OSPF area configured on the interface.
The status of the link and the protocol. Possible status include the
following:
Up.
Down.
The type of OSPFv3 circuit running on the interface. Possible types
include the following:
BCST- Broadcast interface type
P2P- Point-to-point interface type
UNK- The interface type is not known at this time
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents