Brocade Communications Systems FastIron SX 800 Configuration Manual page 345

TABLE 88 show ipv6 ospf interface output descriptions
This field
Authentication
KeyRolloverTime
KeyRolloverState
Current
New (Inbound or Outbound)
Old (Inbound or Outbound)
OSPF messages dropped
Displaying IPsec for a virtual link
To display IPsec for a virtual link, run the show ipv6 ospf virtual-link brief or show ipv6 ospf virtual-link command, as the following
examples illustrate.
device# show ipv6 ospf virtual-link brief
Index Transit Area ID
1 1
device# show ipv6 ospf virtual-link
Transit Area ID Router ID
1 10.14.14.14
Timer intervals(sec) :
Hello 10, Hello Jitter 10,
DelayedLSAck:
Authentication: Configured
KeyRolloverTime(sec): Configured: 10 Current: 0
KeyRolloverState: NotActive
Outbound: SPI:100004, ESP, SHA1
Key:1234567890123456789012345678901234567890
Inbound: SPI:100004, ESP, SHA1
Key:1234567890123456789012345678901234567890
Statistics:
Type tx
Unknown 0
Hello 65
DbDesc 4
LSReq 1
LSUpdate 11
LSAck 5
OSPF messages dropped,no authentication: 0
Neighbor: State: Full Address: 2001:db8:44:44::4 Interface: eth 1/2/2
Syntax: show ipv6 ospf virtual-link [brief]
The optional brief keyword limits the display to the Transit, Area ID, Router ID, Interface Address, and State fields for each link.
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04
Router ID Interface Address
10.14.14.14 2001:db8::1:1:1::1
Interface Address
2001:db8:1:1:1::1
Dead 40, Retransmit 5, TransmitDelay 1
5 times
rx tx-byte
0 0
65 2600
4 2752
1 232
5 1040
8 560
Displays
This field shows whether or not authentication is configured. If this field
says "Not Configured," the IPsec-related fields (bold in example screen
output) are not displayed at all.
The number of seconds between each initiation of a key rollover. This field
shows the configured and current times.
Can be:
Not active: key rollover is not active.
Active phase 1: rollover is in its first interval.
Active phase 2: rollover is in its second interval.
Shows current SPI, authentication algorithm (currently ESP only),
encryption algorithm (currently SHA1 only), and the current key.
Shows new SPI (if changed), authentication algorithm (currently ESP only),
encryption algorithm (currently SHA1 only), and the new key.
Shows old SPI (if changed), authentication algorithm (currently ESP only),
encryption algorithm (currently SHA1 only), and the old key.
Shows the number of packets dropped because the packets failed
authentication (for any reason).
State
P2P
State
P2P
rx-byte
0
2596
2992
64
1112
448
Displaying OSPFv3 information
345