Brocade Communications Systems FastIron SX 800 Configuration Manual page 346

Displaying OSPFv3 information
Changing a key
In this example, the key is changed. Note that the SPI value is changed from 300 to 310 to comply with the requirement that the SPI is
changed when the key is changed.
Initial configuration command.
device(config-if-e10000-1/1/3)# ipv6 ospf auth ipsec spi 300 esp sha1
no-encrypt 12345678900987655431234567890aabbccddef
Command for changing the key.
device(config-if-e10000-1/1/3)# ipv6 ospf auth ipsec spi 310 esp sha1
no-encrypt 989898989009876554321234567890aabbccddef
Displaying IPv6 OSPF information for a VRF
To display IPv6 OSPF information for a VRF or all VRF interfaces, use the show ipv6 ospf vrf command as in the following example.
device# show ipv6 ospf vrf red
OSPF V3 Process number 0 with Router ID 0x10020202(10.2.2.2)
Running 0 days 0 hours 5 minutes 49 seconds
Number of AS scoped LSAs is 0
Sum of AS scoped LSAs Checksum is 00000000
External LSA Limit is 250000
Database Overflow Interval is 10
Database Overflow State is NOT OVERFLOWED
Route calculation executed 0 times
Pending outgoing LSA count 0
Authentication key rollover interval 30 seconds
Number of areas in this router is 4
High Priority Message Queue Full count: 0
Graceful restart helper is enabled, strict lsa checking is disabled
Nonstop Routing is enabled
Syntax: show ipv6 ospf vrf vrf-name [area area-id | virtual-links]
The vrf-name parameter specifies the VRF that you want the OSPF area information for.
The area-id parameter shows information for the specified area.
The virtual-link parameter displays the entry that corresponds to the IP address you enter.
Use the show ipv6 ospf vrf command to display the currently selected IPv6 global address for use by the Virtual Links in each transit
area.
device# show ipv6 ospf vrf red area
Area 3:
Authentication: Not Configured
Interface attached to this area:
Number of Area scoped LSAs is 3
Sum of Area LSAs Checksum is 0001a6c4
Statistics of Area 3:
SPF algorithm executed 3 times
SPF last updated: 302 sec ago
Current SPF node count: 1
Router: 1 Network: 0
Maximum of Hop count to nodes: 0
Area 2:
Authentication: Not Configured
Interface attached to this area:
Number of Area scoped LSAs is 3
Sum of Area LSAs Checksum is 000192d6
Statistics of Area 2:
SPF algorithm executed 3 times
SPF last updated: 302 sec ago
Current SPF node count: 1
Router: 1 Network: 0
346
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04