Table of Contents
Advertisement
Troubleshooting
Abnormal display
The display remains blank when the button is pressed.
Replace the PADRONE DIGITAL battery as described in
Incorrect data appear.
Press only the AC button on the back of the PADRONE DIGITAL to restart it.
The setting values will be maintained.
Why are measurement values flashing?
If using a Cateye sensor, measured values start flashing to indicate that there is little
remaining battery life in the relevant sensor.
Refer to
"Replacing the battery" (Page 43)
sensor.
Errors when using Cateye Cycling™ (Smartphone)
Cannot connect a paired PADRONE DIGITAL with a smartphone (Cateye Cycling™)
Restart Cateye Cycling™. If this does not resolve the issue, restart your smartphone.
(import button) to import summary data is not displayed in the Activity List
•
Have you reset the PADRONE DIGITAL?
To import summary data using Cateye Cycling™, the PADRONE DIGITAL must be
reset (MODE pressed for longer than 2 seconds on any display other than Dst2).
•
If the PADRONE DIGITAL was reset but
Measurements for trips of 0.1 km or less are not recorded as summary data.
Cannot upload data
•
Have you setup the account for each service site?
From
(Menu) in the smartphone app (Cateye Cycling™), tap [Account] and
enter the account information for each site.
•
Cannot share on Facebook or Twitter
In Cateye Cycling™, tap
ter temporarily, and then turn them back on to solve the problem.
"Replacing the battery" (Page
to replace the battery for the relevant
(import button) is not displayed:
(Menu) > [Account], and turn off Facebook and Twit-
46
Cover,
Appendix
Introduction
43).
Using the unit
Using the app
SET
Appendix
1
2
3
4
5
6/8
Hide quick links:
Advertisement
Table of Contents
