Cateye PADRONE DIGITAL CC-PA400B Instruction Manual page 18

Setup with a smartphone (Cateye Cycling™)
7
Activate the sensor.
Use one of the methods in the following table to activate the sensor.
CATEYE sensors
Speed/Cadence sensor
Heart rate sensor
* With the speed/cadence sensor and heart rate sensor, you can also activate the
sensor by pressing the RESET button.
When Cateye Cycling™ detects the sensor signal, a message is displayed on the
smartphone.
Tap [Pairing]. The paired sensor is displayed under [Device] and pairing is completed.
* When pairing a sensor with Cateye Cycling™, an "A" is displayed after the sensor
name.
8
To pair multiple sensors, repeat the procedure from step 6.
Pair all sensors that you intend to use.
9
Set the tire circumference for a sensor capable of speed mea-
surement.
Tap [Sensor name] displayed under [Device], and then tap [Tire Circumference] (the
outer circumference of the tire) to select the tire circumference according to the
tire size written on the side of the tire.
* Default value: 2096 mm (700x23c)
* The tire circumference must be set for each sensor.
10
If necessary, you can change the display of the PADRONE
DIGITAL's measurement screen and its total distance value.
For details, see "Capabilities with a smartphone" (Page 31)
11
Tap (Menu) at the top left of the screen, set [Connect] to OFF.
The PADRONE DIGITAL disconnects from the smartphone and switches to a mea-
surement screen to which the setup details have been applied.
Setting up the PADRONE DIGITAL
Activating the sensor
Move the magnet through the sensor zone several times.
(Within 3 mm)
Rub both electrode pads with your thumbs.
18
Cover,
Introduction
Display
ISC
HR
SET
Appendix
1
2
App
4/4
3
4
5