Cateye PADRONE DIGITAL CC-PA400B Instruction Manual page 8

Mounting the speed/cadence sensor (ISC-12)
3
Adjust the gap between the sensor zone and the magnet.
(1) Tilt the sensor so that the gap between the cadence magnet and the cadence
sensor zone is approximately 3 mm, then fasten the sensor securely with
nylon ties.
(2) Rotate the sensor arm so that the gap between the wheel magnet and the
speed sensor zone is approximately 3 mm, then tighten the sensor screw
securely.
4
Secure all parts.
Securely tighten the sensor's nylon ties, the sensor screw, the wheel magnet, and
the cadence magnet so that they do not move, and then check that these items are
not loose.
Trim off the excess nylon tie.
Cadence magnet
Sensor screw
Wheel magnet
3 mm
8
Mounting the PADRONE DIGITAL
3 mm
3 mm
Cover,
Introduction
1
6/8
2
Using the unit
Using the app
3
4
SET
5
Appendix