Cateye PADRONE DIGITAL CC-PA400B Instruction Manual page 45

Troubleshooting
Measurement does not work
Why is the sensor signal not being received? (Continued)
•
Is the sensor paired with the unit?
The sensor must be paired with the PADRONE DIGITAL. Perform the pairing with
the PADRONE DIGITAL or with a smartphone (Cateye Cycling™).
• PADRONE DIGITAL:
• Smartphone: "Adding a new sensor" (Page 38)
Caution!:
If using a commercial sensor with an iPhone, go back to
[Connect] to OFF and perform pairing with the PADRONE DIGITAL.
"Pairing" (Page 25)
* When using an iPhone, you cannot sync settings of commercial sensors
with the PADRONE DIGITAL.
•
Is the PADRONE DIGITAL or sensor battery flat?
* Battery performance diminishes in winter.
Replace the batteries with new ones as described in
If speed sensor signals or cadence sensor signals are not received
•
Is the clearance between the sensor zone of the sensor and the magnet too
large? (The clearance must be within 3 mm.)
•
Does the magnet pass through the sensor zone correctly?
Adjust the position of the magnet and/or the speed sensor.
If heart rate signals are not received
•
The electrode pad may have slipped out of position.
Check that the electrode pad is still in close contact with your body.
•
Your skin may be dry.
Wet the electrode pad a little.
•
The electrode pad may have deteriorated or become damaged due to prolonged
usage.
If this is the case, replace the attachment belt with a new one.
"Pairing" (Page 25)
Pairing of a commercial sensor and the PADRONE DIGITAL
45
(Menu), set
"Replacing the battery" (Page 43).
Cover,
Appendix
Introduction
Using the unit
Using the app
SET
Appendix
1
2
3
4
5
5/8