Adding A New Sensor - Cateye PADRONE DIGITAL CC-PA400B Instruction Manual

Adding a new sensor

Caution!:
•
To use the PADRONE DIGITAL, you have to pair it with a sensor that supports the
Bluetooth® SMART standard.
•
Avoid pairing sensors at a race venue or in similar locations where there are a lot
of other users. Doing so may cause the PADRONE DIGITAL to be paired with an-
other device.
•
Pairing of a commercial sensor and the PADRONE DIGITAL:
If using a commercial sensor with an iPhone, go back to
to OFF and perform pairing with the PADRONE DIGITAL.
* When using an iPhone, you cannot sync settings of commercial sensors with the
PADRONE DIGITAL.
* The sensor can be paired even when the PADRONE DIGITAL is not connected to a
smartphone. In this case, sensor information will be synchronized with the PADRONE
DIGITAL when connected to a smartphone.
1
On the measurement screen, press MENU to display the
smartphone search screen.
2
Launch Cateye Cycling™, tap
[Reading data from computer...] will be displayed and the smartphone will connect
with the PADRONE DIGITAL. Then follow the procedure on the next page.
PADRONE DIGITAL
MENU
Measurement
screen
Smartphone
38
Capabilities with a smartphone
(Menu), set [Connect]
"Pairing" (Page 25)
Smartphone search
screen
(Menu) and set [Connect] to ON.
Cover,
Introduction
1
2
Using the unit
Using the app
3
4
SET
5
8/10
Appendix